Some experienced pilot that’s able to properly control the Typhoon Q500 4K in Angle (Pilot) Mode, and they do not exceed any altitude/distance limits or fly in any ‘no fly zones’ in your area, they are willing to disable/turn off Typhoon Q500 GPS. So how?
WARNING: Smart Mode and Home Mode, along with their corresponding features, only work when GPS is active and the Q500 has a suitable GPS signal/lock. If you disable/turn off Typhoon Q500 GPS the drone can only be flown in Angle (Pilot) Mode. And if you cannot properly control the Q500 in Angle (Pilot) Mode the aircraft may crash or even ‘fly away’.
IMPORTANT NOTE: Yuneec drone Crash damage and ‘fly aways’ are NOT covered under warranty.We do not typically recommend disabling Typhoon Q500 4K GPS for any reason, especially if you’re a first-time or low-time pilot. However, if you’re an experienced, you could try.
And do NOT disable/turn off Typhoon Q500 4K GPS unless you accept ALL responsibility and liability for crashes or ‘fly aways’.
IMPORTANT NOTE: Every time you turn the Q500 on it will default to having Typhoon Q500 4K GPS active/on (even if you disabled GPS the last time is was powered on).
Step 1) While the ST10 and Q500 are powered on and linked (and the motors are NOT running), move the Proportional Control Rate Slider on the right side of the ST10 to the uppermost (rabbit) position.
Step 2) Move the right-hand stick all the way to the right and hold it there until step 3 is completed.
Step 3) Move the Flight Mode Selection Switch from Smart to Home and Home to Smart mode 4 times in 3 seconds.When GPS has been disabled successfully the Q500 will emit an audible indication and the Typhoon Q500 4K GPS status on the ST10 screen will show ‘Disabled’.
Also, the Main LED Status Indicator will flash purple and the Below Motor LED Status Indicators will flash three times per second then will stay off for one second.
The post Indoor flights with Typhoon Q500 4K gps off appeared first on Drone Inner.
No comments:
Post a Comment